Post Reply 
HP42S with non-volatile ram
09-29-2020, 01:41 AM (This post was last modified: 09-29-2020 01:42 AM by GreyUser.)
Post: #7
RE: HP42S with non-volatile ram
As is typical for HP pc board layouts, all chips have their pin 1 facing in the same orientation.

The cpu pin 1 indicator is obvious with the protective plastic frame removed from the tab package. With the frame in place, it is approximately 50% covered. It is the round, hollow circle in tinned copper on the kapton film of the chip carrier, in the lower right hand corner. It is above pin 14 of the ram chip, partiality obscured by the protection frame. Above 1/2 of the diameter can been seen with the plastic frame in place.

I have completed a pinout of the LCD, only hand drawn at this time. I would be happy to share with you if wanted, send me a PM. I intend to make a formal drawing and add it to the archives here on the museum when time permits. I am the author of the Pioneer keyboard schematic that you referenced that is in the archives here.

Thank you for sharing all your excellent work with the 42S!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP42S with non-volatile ram - GreyUser - 06-11-2020, 04:40 AM
RE: HP42S with non-volatile ram - mfleming - 06-11-2020, 02:26 PM
RE: HP42S with non-volatile ram - lyuka - 09-26-2020, 12:12 PM
RE: HP42S with non-volatile ram - GreyUser - 09-28-2020, 02:41 AM
RE: HP42S with non-volatile ram - lyuka - 09-28-2020, 01:13 PM
RE: HP42S with non-volatile ram - GreyUser - 09-29-2020 01:41 AM
RE: HP42S with non-volatile ram - lyuka - 09-29-2020, 09:48 AM
RE: HP42S with non-volatile ram - lyuka - 11-17-2020, 06:11 PM
RE: HP42S with non-volatile ram - G-SAN - 02-06-2024, 03:54 PM



User(s) browsing this thread: 1 Guest(s)