HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Getting rid of wrong Windows10 drivers (Clonix/Nov)

Post Reply 
Getting rid of wrong Windows10 drivers (Clonix/Nov)
08-08-2020, 02:49 AM (This post was last modified: 08-08-2020 02:51 AM by Mark Hardman.)
Post: #12
Mark Hardman Offline
Senior Member
 		Posts: 525
Joined: Dec 2013
RE: Getting rid of wrong Windows10 drivers (Clonix/Nov)
(08-07-2020 08:06 PM)Diego Diaz Wrote:  The pre-2013 reference extends to every Clonix-41(d), NoVRAM and NoV-32.

They were all discontinued on Dec. 15 2013 after the 10th. Anniversary.

However, although the new Config61 will not handle these modules, the pogrammer itself can be used to configure them with the .HEX files generated under the Config42 utility.

In our email communication, I was left with the impression that the new programmer is not compatible with my NoV-64d that was part of the 10th Anniversary bundle. Could you please clarify if it is or is not compatible? If it is, I would love to place an order for one of the new programmers.

Warmest regards,
Ceci n'est pas une signature.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Getting rid of wrong Windows10 drivers (Clonix/Nov) - Mark Hardman - 08-08-2020 02:49 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication