The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 795 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 795 errorHandler->error





Post Reply 
Arg on HP Prime
08-15-2020, 10:03 AM
Post: #1
Arg on HP Prime
Dear fellow HP users,

This may have been asked before or a stupid question, but I can't figure out where the ARG function is on the Prime.
I have used HP 48 and 50 since they came out and after calculation, you could do right shift EEX to get the arguments back on the screen.
Say 10 enter 5 +
Answer 15
Richt shift EEX (ARG) will show 10 and 5 again.

This is a very useful function and I can not find it on the prime.
I like to use the calculator in RPN, because I am used to that, but in that mode the arguments are not automatically shown on the left side of the screen.

Any help is much appreciated,

Hubert
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Arg on HP Prime - Plantarum - 08-15-2020 10:03 AM
RE: Arg on HP Prime - Stevetuc - 08-15-2020, 01:22 PM
RE: Arg on HP Prime - Plantarum - 08-15-2020, 10:05 PM



User(s) browsing this thread: