[WP-34S] Troubleshoot internal USB Board
|
01-22-2021, 12:26 AM
Post: #3
|
|||
|
|||
RE: [WP-34S] Troubleshoot internal USB Board
My computer is Windows 10, and I am running MySamba as Adminstrator.
My 34S was flashed with an older version of the firmware, and I was attempting to update it via the flashing procedure I have always used, namely HP cable with Prolific Serial Converter and MySamba. It has the USB board installed, but I could not get it flashing that way previously, so I use the HP cable instead. I have the PDF Version of the WP-34S v3.3 Manual. In Appendix A, I follow all steps until step A9: "A9. Now click "Send File" in the MySamBa window", at which point MySamba, after a few seconds says "unable to connect". I have successfully flashed 3 other units today using the same procedure, with 100% success. These other 3 units do not have the USB board. Batteries are measured at 3V each. -- Sanjeev Visvanatha |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[WP-34S] Troubleshoot internal USB Board - Sanjeev Visvanatha - 01-19-2021, 05:29 PM
RE: [WP-34S] Troubleshoot internal USB Board - John Galt - 01-21-2021, 04:35 PM
RE: [WP-34S] Troubleshoot internal USB Board - Sanjeev Visvanatha - 01-22-2021 12:26 AM
RE: [WP-34S] Troubleshoot internal USB Board - John Galt - 01-22-2021, 12:44 AM
RE: [WP-34S] Troubleshoot internal USB Board - Sanjeev Visvanatha - 01-22-2021, 01:02 AM
RE: [WP-34S] Troubleshoot internal USB Board - Harald - 01-23-2021, 09:35 PM
RE: [WP-34S] Troubleshoot internal USB Board - Sanjeev Visvanatha - 01-24-2021, 03:31 AM
|
User(s) browsing this thread: 1 Guest(s)