FRAM71B installation
|
02-03-2021, 03:02 PM
Post: #13
|
|||
|
|||
RE: FRAM71B installation
Hello Hans,
I saw that the module was initially setup with top FRAM enabled, top FRAM write disabled and E0000 mapping enabled. I found that strange, so I plugged the module, saw that Forth was there and some other modules. I thought that it was tests leftover so I reconfigured the module then did a full cleanup of both top and bottom content. It was while doing that cleanup that I saw the unexpected behavior. Anyway, I have reread the FRAM71B manual and for some unknown reasons I had skipped some information in there that is specific to the second generation module. I just realized that all my pasts experiments has been done on the FRAM71 and used the FRAM71B with safe config only. I am back to square one, well, not exactly one but very near, so I need time to experiments FRAM71B specific options and edge cases. I have setup three 71B for testing:
Sylvain |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)