USB41 while upgrading the 41CL
|
02-24-2021, 08:22 PM
(This post was last modified: 02-24-2021 08:27 PM by aurelio.)
Post: #5
|
|||
|
|||
RE: USB41 while upgrading the 41CL
(02-23-2021 05:14 PM)burkhard Wrote: It's been a while since I've updated my 41CL's flash (shame!), but I believe the last few times I've done it, I indeed used my USB-41 as an additional power supply. I'm pretty sure it works fine.I've done this time the calculators' upgrade without the extra power, because I got trouble while doing the 41CL basic setup and particularly PLUG(ging)1L the YFNX... I got a message... , something like "the port you are trying yo use is already busy" .. of course in a shorter form . Maybe I should have just swapped the USB41 port , or erased the module before to use it like a simple power source to avoid whatever conflict .. I'll try it forward, I have been so lazy this time in avoiding the "extra job" requested to erase the module and rewrite it after the upgrade |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
USB41 while upgrading the 41CL - aurelio - 02-19-2021, 10:55 PM
RE: USB41 while upgrading the 41CL - Sylvain Cote - 02-20-2021, 12:22 AM
RE: USB41 while upgrading the 41CL - aurelio - 02-20-2021, 09:34 PM
RE: USB41 while upgrading the 41CL - burkhard - 02-23-2021, 05:14 PM
RE: USB41 while upgrading the 41CL - aurelio - 02-24-2021 08:22 PM
RE: USB41 while upgrading the 41CL - Sylvain Cote - 02-24-2021, 09:18 PM
RE: USB41 while upgrading the 41CL - aurelio - 02-24-2021, 09:28 PM
RE: USB41 while upgrading the 41CL - Sylvain Cote - 02-24-2021, 10:04 PM
|
User(s) browsing this thread: 1 Guest(s)