Post Reply 
ID this calculator
03-13-2021, 05:45 AM
Post: #9
RE: ID this calculator
(03-12-2021 08:01 PM)Eric Rechlin Wrote:  The 10bII (note the capitalization) had two different industrial designs, one from the ACO era and one from the post-ACO era; the later industrial design was retained for the 10bII+. This is the later design.

Forgive me all for my lack of knowledge, especially in calculators and english acronyma. Yesterday I've surfed on the web looking for ACO, and found here a lot of explanations, but probably not the right one. Erich can you help me, please, I'm quite lost
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ID this calculator - David Hayden - 03-12-2021, 02:18 PM
RE: ID this calculator - AndiGer - 03-12-2021, 02:52 PM
RE: ID this calculator - David Hayden - 03-12-2021, 07:54 PM
RE: ID this calculator - rprosperi - 03-12-2021, 03:15 PM
RE: ID this calculator - aurelio - 03-12-2021, 06:47 PM
RE: ID this calculator - Gerson W. Barbosa - 03-14-2021, 09:37 AM
RE: ID this calculator - Massimo Gnerucci - 03-14-2021, 10:10 AM
RE: ID this calculator - rprosperi - 03-14-2021, 12:48 PM
RE: ID this calculator - Didier Lachieze - 03-14-2021, 01:15 PM
RE: ID this calculator - aurelio - 03-14-2021, 02:47 PM
RE: ID this calculator - Gerson W. Barbosa - 03-14-2021, 03:26 PM
RE: ID this calculator - rprosperi - 03-14-2021, 04:54 PM
RE: ID this calculator - Gerson W. Barbosa - 03-14-2021, 05:38 PM
RE: ID this calculator - DanM - 03-12-2021, 06:50 PM
RE: ID this calculator - aurelio - 03-12-2021, 07:36 PM
RE: ID this calculator - Dave Shaffer - 03-13-2021, 08:05 PM
RE: ID this calculator - aurelio - 03-14-2021, 12:02 AM
RE: ID this calculator - Eric Rechlin - 03-12-2021, 08:01 PM
RE: ID this calculator - aurelio - 03-13-2021 05:45 AM
RE: ID this calculator - Steve Simpkin - 03-13-2021, 07:50 AM
RE: ID this calculator - aurelio - 03-13-2021, 08:59 AM
RE: ID this calculator - Eddie W. Shore - 03-14-2021, 03:49 PM
RE: ID this calculator - rprosperi - 03-14-2021, 05:43 PM



User(s) browsing this thread: 1 Guest(s)