Post Reply 
HP-30b - dead key - repair
06-17-2014, 07:27 PM
Post: #2
RE: HP-30b - dead key - repair
(06-17-2014 07:21 PM)pito Wrote:  We converted two WP34s successfully, but after a while the Enter key on one unit stopped clicking.
You should as well have a look at the overlay. If the label sheet is to close to the cutout the key cannot move freely.

Marcus von Cube
Wehrheim, Germany
http://www.mvcsys.de
http://wp34s.sf.net
http://mvcsys.de/doc/basic-compare.html
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP-30b - dead key - repair - pito - 06-17-2014, 07:21 PM
RE: HP-30b - dead key - repair - Marcus von Cube - 06-17-2014 07:27 PM
RE: HP-30b - dead key - repair - pito - 06-17-2014, 07:41 PM
RE: HP-30b - dead key - repair - walter b - 06-17-2014, 08:05 PM
RE: HP-30b - dead key - repair - jebem - 06-18-2014, 05:30 AM
RE: HP-30b - dead key - repair - pito - 06-18-2014, 10:42 AM
RE: HP-30b - dead key - repair - Jeff O. - 06-18-2014, 12:49 PM
RE: HP-30b - dead key - repair - pito - 06-18-2014, 06:18 PM
RE: HP-30b - dead key - repair - Jeff O. - 06-19-2014, 02:42 PM
RE: HP-30b - dead key - repair - pito - 06-19-2014, 04:27 PM
RE: HP-30b - dead key - repair - Jeff O. - 06-19-2014, 02:35 PM
RE: HP-30b - dead key - repair - pito - 06-19-2014, 04:39 PM
RE: HP-30b - dead key - repair - pito - 06-20-2014, 04:53 PM
RE: HP-30b - dead key - repair - jebem - 06-20-2014, 06:03 PM
RE: HP-30b - dead key - repair - pito - 06-20-2014, 06:33 PM



User(s) browsing this thread: 1 Guest(s)