HP-30b - dead key - repair

[pito]

(06-18-2014 12:49 PM)Jeff O. Wrote:  Does this help?

Thanks! Provided it is a fresh picture of 30b - would it be possible to make a picture of the single pcb dome/contact (?) and a detail of a molded key assembly from the bottom?
We decided to work with the loose key until the next one dies - then we will open the stuff.

I plan to drill a conical hole (with the tip of a 2-3mm dia drill bit) into the holes which fix the plastic rivets - then I will mold the rivets into. It may fix the stuff even better than the epoxy.