testing a 41cv before attempting lower post repair
|
07-26-2021, 12:32 PM
Post: #8
|
|||
|
|||
RE: testing a 41cv before attempting lower post repair
2-56 is the size of the (small) screws that thread into the standoff. I apparently didn't make notes about the length and diameter, but the diameter was turned down to allow the standoff I bought to fit through the holes in the 41CL board, and the length to allow the back case to close fully. I turned them down by chucking the standoffs into a drill and using a grinding wheel.
|
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
testing a 41cv before attempting lower post repair - dmh - 07-21-2021, 08:38 AM
RE: testing a 41cv before attempting lower post repair - mfleming - 07-21-2021, 02:30 PM
RE: testing a 41cv before attempting lower post repair - dmh - 07-24-2021, 07:28 AM
RE: testing a 41cv before attempting lower post repair - BillBee - 07-26-2021, 10:19 AM
RE: testing a 41cv before attempting lower post repair - mfleming - 07-24-2021, 02:45 PM
RE: testing a 41cv before attempting lower post repair - cruff - 07-24-2021, 10:45 PM
RE: testing a 41cv before attempting lower post repair - dmh - 07-26-2021, 11:32 AM
RE: testing a 41cv before attempting lower post repair - cruff - 07-26-2021 12:32 PM
|
User(s) browsing this thread: 1 Guest(s)