Post Reply 
FORTH for the SHARP PC-E500 (S)
09-22-2021, 10:55 AM
Post: #12
RE: FORTH for the SHARP PC-E500 (S)
(09-17-2021 09:25 PM)toml_12953 Wrote:  1200 is the baud rate. The manual is here:

http://pocketcomputerworld.free.fr/Manuals/PC-E500.pdf

Pages 303-305 have the syntax and usage of the OPEN command.

Right. It appears I had misunderstood the role of format 2.

(09-21-2021 06:12 PM)robve Wrote:  Have you tried sending Forth500.OBJ over serial and load it with LOADM "FORTH500.OBJ"?

It should not work, as the manual states that "the computer can send/receive only ASCII codes" (p. 304).
I've tried nevertheless to load a binary file with the LOADM command, with various syntaxes, but I got either a 'syntax error', or a 'bad drive name' error.

Instead, I've written a small program that converts any binary file into an ASCII file. It's a DOS program (I'm not a modern guy!), so it needs DOSBOX to run. I still have to adapt the BASIC loader and test it, but it should work.

Jean-Charles
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
FORTH for the SHARP PC-E500 (S) - Helix - 09-06-2021, 11:41 PM
RE: FORTH for the SHARP PC-E500 (S) - dmh - 10-02-2022, 02:29 PM
RE: FORTH for the SHARP PC-E500 (S) - dmh - 10-04-2022, 12:46 PM
RE: FORTH for the SHARP PC-E500 (S) - dmh - 10-04-2022, 10:55 PM
RE: FORTH for the SHARP PC-E500 (S) - Helix - 09-22-2021 10:55 AM



User(s) browsing this thread: 1 Guest(s)