Interval and Parameter
|
01-09-2022, 01:24 PM
Post: #10
|
|||
|
|||
RE: Interval and Parameter
(01-08-2022 04:33 PM)parisse Wrote: Not exactly the same, but from the geometry app, you can define a parameter and a function depending on the parameter, then moving the parameter will represent the corresponding curve. Thanks! I tried it with a list, and it works too. I still kinda wish there is a way of doing it in the function app, as I couldn't trace the functions or get any important points without entering many equations and commands in the NUM and SYMB View. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Interval and Parameter - Eulehund99 - 01-06-2022, 06:52 PM
RE: Interval and Parameter - roadrunner - 01-07-2022, 05:25 PM
RE: Interval and Parameter - Eulehund99 - 01-08-2022, 12:22 AM
RE: Interval and Parameter - pinkman - 01-08-2022, 07:26 AM
RE: Interval and Parameter - Wes Loewer - 01-08-2022, 08:21 AM
RE: Interval and Parameter - C.Ret - 01-08-2022, 03:11 PM
RE: Interval and Parameter - parisse - 01-08-2022, 04:33 PM
RE: Interval and Parameter - Eulehund99 - 01-09-2022 01:24 PM
RE: Interval and Parameter - IHarwell - 01-08-2022, 09:58 PM
RE: Interval and Parameter - Eulehund99 - 01-09-2022, 12:49 PM
|
User(s) browsing this thread: 1 Guest(s)