WP34s Programming Cable
|
01-31-2014, 04:39 PM
Post: #44
|
|||
|
|||
RE: WP34s Programming Cable
That looks really good. Which size pogo pins did you use? Here's a table that I got from Ebay:
P50: Dia.=0.68mm, L=16.55mm P75: Dia.=1.02mm, L=16.50mm P100: Dia.=1.36mm, L=33.30mm I used the P50 size because that looked like it would fit in the machine sockets that I used. But they were quite loose until I soldered them in. Of course, I had to keep them aligned while soldering. I'm guessing you used something bigger. I think you've got a nice looking connector there, though. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 2 Guest(s)