67 Mag card with both program and data

[teenix]

(06-01-2022 10:53 PM)Dave Britten Wrote:  Yup. Just have a program that's no more than 112 steps on one side, and data from only the primary registers on the other.

I think I've read some tips/articles in PPC Journal that mentioned having more steps/data in memory when writing the card so that you still get one side of the card prompting you with "CRD" to pass the other side through.

Also, programs with more than 112 steps or maximum RAM storage doesn't have to go on the same card, but it is more sensible. It also doesn't matter which side of the card you put in first when reading, the microcode figures it out from the Status information on the card side.

cheers

Tony