Post Reply 
What am I doing wrong - HP42 (DM42)
10-04-2022, 02:18 AM
Post: #2
RE: What am I doing wrong - HP42 (DM42)
Some things to try, in this order, checking if it's fixed after each step:

1. Shift-SETUP-2 Load Clean State

2. Insert a paper-clip into the reset hole on the back side

3. Reinstall the latest DM42 firmware, available here:

If none of these steps solves the problem, it is likely a h/w issue.

How old is this DM42?

--Bob Prosperi
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: What am I doing wrong - HP42 (DM42) - rprosperi - 10-04-2022 02:18 AM
Swiss Micros Support - rkumetz - 10-04-2022, 12:42 PM

User(s) browsing this thread: 1 Guest(s)