USBOpen(), USBSend() and USBRecv()
|
05-01-2023, 08:43 PM
(This post was last modified: 05-01-2023 10:20 PM by matalog.)
Post: #14
|
|||
|
|||
RE: USBOpen(), USBSend() and USBRecv()
(05-01-2023 07:41 PM)gehakte_bits Wrote: Not familiar with your terminal program. But you could monitor the Async link data to see what side loses it. Xon/Xoff has fixed that. Now I get everything in all different sized packets, but at least I get it all. Thanks again. I ordered i2c to UART devices and in the meantime, I will attempt to use an Arduino to send 60 bytes via i2c. If I tell the arduino to Wire.begin(80) that is 50h, then should I be able to Wire.write("12345abcde") and receive it on the HP Prime, assuming I have the FT260 JP9 at 2-3 and JP 7 at 1-2. I will connect Arduino SCL-SDA-GND to FT260 SCL-SDA-GND. Is there anything else I will need to set first? |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)