Post Reply 
Reproducing tiny plastic gears for vintage 'gear'
08-20-2023, 11:05 PM
Post: #12
RE: Reproducing tiny plastic gears for vintage 'gear'
After testing multiple resins, I found that the one I had originally tried was by far the best. This is rather ironic as if I had not started with it, I may have declared the project impossible.

I am looking for a few beta testers, people who are in need of this gearset for their Alps mech. Feedback is vital. I am in the USA so other folks in the USA are preferred as it makes shipping less expensive. I have run the gears for a few hours of printing time, so I think they will be fairly robust but I'm sure they will not last for decades.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Reproducing tiny plastic gears for vintage 'gear' - Jeff_Birt - 08-20-2023 11:05 PM



User(s) browsing this thread: 1 Guest(s)