HP 41C DOES NOT BEEP
|
08-30-2014, 06:44 PM
(This post was last modified: 08-30-2014 06:46 PM by jebem.)
Post: #11
|
|||
|
|||
RE: HP 41C DOES NOT BEEP
(08-30-2014 05:31 PM)aurelio Wrote: I think maybe the "beep" missing could be due to a cold soldering, I added a magnified pic of the board and it seems the upper point could be one of those. Hi Aurelio, good work! After getting this far, if I were you I would use a new 15 watt low power pen soldering iron to unplug the two wires. Then remove that solder mess on the PCB. Clearly it was not correctly soldered. Now you need a audio oscillator (I use my multimeter that has a built in 2Khz signal) to test the buzzer and make sure it works. Then resolder the wires using a low melting point good quality solder, using adequate heating to make a good solder joint (if the soldering iron requires more than 2 seconds to make an good melting it means you are using a underpowered tool). Good luck with it. Jose Mesquita RadioMuseum.org member |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)