MOUSE command problem (FW 2.1.14730)

[matalog]

There is something strange about the Mouse driver though, whether it is hardware or software based, i'm not sure. If you move your finger onto the screen from any side of the screen everything is fine, unless the side you move on from is the bottom, then MOUSE() will only register the initial x position and hold the 239 value as bottom of screen.

PS: I just realised as I was typing the last part that they must have kept the same code for the soft button menus in place for even MOUSE, as it would be a decent decision to ignore movements in from the bottom of screen if there were definitely going to be soft buttons there. Not a great decision when there are not definitely going to be soft buttons there.