WP 34S and 31S bugs and fixes

[Nigel (UK)]

(12-24-2014 01:11 PM)Bit Wrote:  

(12-23-2014 08:50 PM)Nigel (UK) Wrote:  Mini-bug in r3716 and probably earlier ones too:

With the calc_full.bin firmware, the X.FCN catalogue has a ??? entry in between sRCL and TIME (where the STOPW application would be). Executing this gives an "Undefined op-code" error, which should never happen according to the manual! A problem caused by this is that searches for commands near the end of the alphabet get stuck at this point, rather than reaching the correct command.

Nigel (UK)

I couldn't reproduce this issue.

Which binary were you using? Did you compile it yourself? If so, which compiler did you use and what was in features.h?

I used the calc_full.bin binary. I compiled it myself; the gcc version is 4.8.1 from MinGW and 4.7.2 from the yagarto installation. (I'm doing this on Windows.) I'd need to look at the makefile to be sure which one is actually being used; you are probably much more familiar with this than I am. I haven't done anything with the compiler since I first installed it a couple of years ago. Before compiling I made a fresh checkout of version 3716 into a clean directory, making no changes to features.h before compiling.

Nigel (UK) (Edited for clarity)