WP 34S and 31S bugs and fixes

[Nigel (UK)]

(12-25-2014 12:51 AM)Marcus von Cube Wrote:  

(12-24-2014 10:37 PM)Nigel (UK) Wrote:  I have checked out build 3717 into a new folder and built the firmware files using a yagarto with gcc version 4.6.0 . I have loaded calc.bin (and yes, it is the new one and not an older one!) into a calculator, erasing rather than updating. The problem is still there - opening X.FCN and then pressing 3 (to go to the Version command) brings up ???. ...

Strange. Can you post catalogues.h after a compile of calc.bin? I will compare it against my local copy. What are your steps to compile the stuff? Are you using the .cmd files provided?

Going back to old builds (3500 or so) which I know compiled correctly at the time the problem persists. The calc.bin file provided in the older builds is fine; the one I compile myself with an unmodified features.h file has the problem described above. The procedure I have followed is:

• Make a new directory
• Use svn to check out the latest build into that directory
• Make the same changes to create_revision.c and wp34s_asm.pl that I have been making for the past two years. In create_revision.c I put in an explicit temporary file name to replace the automatically generated one that doesn't work; in wp34s_asm.pl I change the line
  Code:
  

  my $preproc_fallback_dir = "";
  to
  Code:
  

  my $preproc_fallback_dir = "C:/Users/nd/wp34s/stop_test_3/trunk/tools/";
  where the directory I've typed is the correct one on my computer.
• Run makeflash
  

The calc.bin file generated in this way has the ??? entry in X.FCN described above when loaded onto my calculator

I have attached catalogues.h (renamed). I really don't know what has changed to cause this problem. Thank you for trying to help!

Nigel (UK)