How's WP-43S Project Going?
|
12-31-2013, 09:20 AM
Post: #11
|
|||
|
|||
RE: How's WP-43S Project Going?
Wow you are so experienced brouhaha. I never successfully persuaded my father to buy one. Maybe he is a little conservative or 3D printer just doesn't meet the need of the factory.
(12-31-2013 07:45 AM)brouhaha Wrote: I may have a line on getting molds made for substantially less money than the RMB 300000 yuan you quote. Well the "300000 yuan" budget is quite inaccurate. It should be 30000 or so but the cost still can vary a lot. XD |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
How's WP-43S Project Going? - Waon Shinyoe - 12-29-2013, 02:03 PM
RE: How's WP-43S Project Going? - Geoff Quickfall - 12-29-2013, 02:12 PM
RE: How's WP-43S Project Going? - Waon Shinyoe - 12-29-2013, 02:24 PM
RE: How's WP-43S Project Going? - walter b - 12-29-2013, 06:50 PM
RE: How's WP-43S Project Going? - Waon Shinyoe - 12-30-2013, 11:02 AM
RE: How's WP-43S Project Going? - jwm - 12-30-2013, 04:07 AM
RE: How's WP-43S Project Going? - Thomas Radtke - 12-30-2013, 10:29 AM
RE: How's WP-43S Project Going? - brouhaha - 12-30-2013, 06:17 PM
RE: How's WP-43S Project Going? - Waon Shinyoe - 12-31-2013, 05:32 AM
RE: How's WP-43S Project Going? - brouhaha - 12-31-2013, 07:45 AM
RE: How's WP-43S Project Going? - Waon Shinyoe - 12-31-2013 09:20 AM
|
User(s) browsing this thread: 1 Guest(s)