HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Easiest groups/lineages of machines to port software between?

Post Reply 
Easiest groups/lineages of machines to port software between?
05-10-2015, 10:13 PM (This post was last modified: 05-10-2015 10:15 PM by Csaba Tizedes.)
Post: #3
Csaba Tizedes Offline
Senior Member
 		Posts: 607
Joined: May 2014
RE: Easiest groups/lineages of machines to port software between?
(05-10-2015 09:17 PM)Dave Britten Wrote:  going from 32Sii to 35S is relatively painless.

I have a hydrostatics example where the program code totally same for the two calculator and the 32Sii can to SOLVE that program and after few seconds gives a result but 35s can't.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Easiest groups/lineages of machines to port software between? - Csaba Tizedes - 05-10-2015 10:13 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication