HP Forums / HP Calculators (and very old HP Computers) / HP Prime v / Issue with Defined User function (in FW 7820)

Post Reply 
Issue with Defined User function (in FW 7820)
05-15-2015, 08:05 AM
Post: #3
salvomic Offline
Senior Member
 		Posts: 1,396
Joined: Jan 2015
RE: Issue with Defined User function
(05-14-2015 11:17 PM)DrD Wrote:  I discovered that in r7820 setting HAngle doesn't work. Therefore your angle mode may be wrong for calculations that rely on HAngle for radian / degree mode selection.

I had a few programs that wouldn't work due to HAngle being ignored. The default setting was radians, but the programs used degree mode!

here angles are Radiant in Home and CAS Settings.

In CK -> Variables I find always ramp (my function that was X=(X+abs(X))/2) and if I clic there I get "Error: Invalid object"; in the Prime Mem -> User Variables I have "Ramp (Error), if I delete it and reset (On+Symb) it return again...

Salvo
∫aL√0mic (IT9CLU) :: HP Prime 50g 41CX 71b 42s 39s 35s 12C 15C - DM42, DM41X - WP34s Prime Soft. Lib
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Issue with Defined User function - DrD - 05-14-2015, 11:17 PM
RE: Issue with Defined User function - salvomic - 05-15-2015 08:05 AM



User(s) browsing this thread: 2 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication