41CX halfnut keyboard not responding
|
12-14-2015, 06:00 PM
Post: #10
|
|||
|
|||
RE: 41CX halfnut keyboard not responding
Thanks, everyone, for all the helpful replies! As I mentioned, the enhancement module was transplanted to another CX. That other CX worked fine with the bad enhancement module but lacked the X functions and/or time. I will solder in the bad module to this CX and see if it starts responding.
A related question: do you think it's feasible to desolder that 44-pin CPU with hot air, provided I use kapton tape over the heat stakes? I have another CX with a bad LCD that could be a possible donor. |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)