HP Forums / HP Calculators (and very old HP Computers) / General Forum v / Programming the INT and FRAC functions

Post Reply 
Programming the INT and FRAC functions
01-04-2016, 07:45 PM (This post was last modified: 01-04-2016 07:45 PM by Didier Lachieze.)
Post: #12
Didier Lachieze Offline
Senior Member
 		Posts: 1,630
Joined: Dec 2013
RE: Programming the INT and FRAC functions
(01-04-2016 07:34 PM)Dieter Wrote:  You could just as well use [.] [5] [–], but [→H.MS] [→H.MS] is one step shorter. ;-)

On the HP-55 [→H.MS] [→H.MS] uses 4 steps (keystrokes are not merged) so it's one step longer, but it's better because [.] [5] [–] doesn't work with negative numbers.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Programming the INT and FRAC functions - Didier Lachieze - 01-04-2016 07:45 PM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication