Right Arrow Character in Connectivity Kit?
|
02-28-2016, 08:05 PM
Post: #1
|
|||
|
|||
Right Arrow Character in Connectivity Kit?
Hello again,
I use the HP Connectivity Kit to write and edit my HP Prime programs. I recently had the opportunity to use the R->B (real-to-binary) command, and I typed in a minus sign and a greater than sign as I did in this sentence. When I transfer my program into my Prime, I get a syntax error in between the two characters. I can delete those two characters and the use the Chars key to get a right-arrow character (on page 10 of the Chars). How can I type the right arrow character in the HP Connectivity Kit? If I have a program with many R->B commands, it will be tedious to edit them all after I transfer my program into the Prime. I tried looking at my program in the Prime after I edited in the correct character, but in the HP Connectivity Kit window, it displays as '->' too, so I cannot copy the correct character over from the Prime into the HP Connectivity Kit. Thanks in advance for any advice you may have. smp |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Right Arrow Character in Connectivity Kit? - smp - 02-28-2016 08:05 PM
RE: Right Arrow Character in Connectivity Kit? - DrD - 02-28-2016, 11:36 PM
RE: Right Arrow Character in Connectivity Kit? - smp - 03-01-2016, 12:22 AM
|
User(s) browsing this thread: 2 Guest(s)