Post Reply 
HP-28S preservation
08-02-2016, 05:10 PM
Post: #6
RE: HP-28S preservation
(08-02-2016 11:53 AM)striegel Wrote:  
(08-02-2016 11:17 AM)Dave Britten Wrote:  I faintly remember seeing some kind of battery retainer that somebody had fashioned which looked like a bent wire hanger (it wasn't; it looked much nicer) that wrapped around the left side of the body, under the case, and around the outside of the batteries, holding them in without the outward pressure on the battery door slot. Did anything like that ever get produced in (relatively) large numbers?
Yes, I've seen that.

But I don't know who was responsible for the original. It seems unlikely to have been produced in quantity.

AJ made these several years ago. Last time this topic came up, he said he didn't have any left over, unfortunately.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
HP-28S preservation - James P.G. Sterbenz - 08-01-2016, 09:41 PM
RE: HP-28S preservation - Accutron - 08-01-2016, 10:28 PM
RE: HP-28S preservation - Dave Britten - 08-02-2016, 11:17 AM
Stainless steel strap for 28S - striegel - 08-02-2016, 11:53 AM
RE: HP-28S preservation - BobVA - 08-02-2016 05:10 PM
RE: HP-28S preservation - Paul Dale - 08-02-2016, 11:21 AM



User(s) browsing this thread: 1 Guest(s)