HP Forums / HP Calculators (and very old HP Computers) / General Forum v / New SwissMicros Firmware

Post Reply 
New SwissMicros Firmware
10-28-2016, 06:34 PM (This post was last modified: 10-28-2016 06:37 PM by Chasfield.)
Post: #11
Chasfield Offline
Member
 		Posts: 119
Joined: Sep 2015
RE: New SwissMicros Firmware
I just got around to flashing V21 onto my DM15. I have run V16 since purchase and I always had a problem with my '5' key, which was slightly unresponsive. It required follow-through pressure, after the click, to make it fire. I always assumed that this was due to a bad click dome but it must have been a timing issue. With V21 firmware installed, I now can't make it not fire - if it clicks it generates a 5 character, no matter how marginal the actuating pressure I use. I am very pleased with the improvement.

Has anybody experienced similar problems with the older firmware versions?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
New SwissMicros Firmware - toml_12953 - 10-26-2016, 12:42 PM
RE: New SwissMicros Firmware - wojtek - 10-27-2016, 01:58 AM
RE: New SwissMicros Firmware - emece67 - 10-27-2016, 08:26 AM
RE: New SwissMicros Firmware - emece67 - 10-27-2016, 08:07 AM
RE: New SwissMicros Firmware - rprosperi - 10-27-2016, 01:43 PM
RE: New SwissMicros Firmware - toml_12953 - 10-28-2016, 11:21 AM
RE: New SwissMicros Firmware - toml_12953 - 10-28-2016, 11:23 AM
RE: New SwissMicros Firmware - Chasfield - 10-28-2016 06:34 PM
RE: New SwissMicros Firmware - emece67 - 11-01-2016, 10:33 PM
RE: New SwissMicros Firmware - rprosperi - 11-01-2016, 11:16 PM
RE: New SwissMicros Firmware - rprosperi - 11-02-2016, 01:26 PM
RE: New SwissMicros Firmware - toml_12953 - 11-02-2016, 07:24 AM



User(s) browsing this thread: 1 Guest(s)

Contact Us | The Museum of HP Calculators | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication