HP97 printer gear replacement
|
12-15-2021, 11:08 PM
Post: #14
|
|||
|
|||
RE: HP97 printer gear replacement
(12-15-2021 09:44 PM)Kees Bouw Wrote:(12-15-2021 03:54 PM)wbvreeuwijk Wrote: I recently 3D-printed a few of these gears and they seem to work ok. (the top ones are what was left of the original gears :-) I believe this too and mentioned awhile back that it may be due to the fact that if the PIK chip or home switch failed, the motor could keep running and drive the print carriage into the printer frame and cause a motor stall and subsequent damage. It is possible that this gear is sacrificial in this type of fail. It may also keep the printer noise low. cheers Tony |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)