Post Reply 
WP34 resets when using Y^X
03-02-2014, 02:50 PM
Post: #8
RE: WP34 resets when using Y^X
You should measure the voltage under load. A short loop with BATT (and no PSE) will force the calculator to run at full speed and thus BATT should report the voltage under load. Give it some time (a few seconds) before you stop the loop with R/S. The reason is the adaptive approach of the battery level detecting algorithm. The processor just features a brown out detector.

Marcus von Cube
Wehrheim, Germany
http://www.mvcsys.de
http://wp34s.sf.net
http://mvcsys.de/doc/basic-compare.html
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
WP34 resets when using Y^X - Randy - 02-28-2014, 02:03 AM
RE: WP34 resets when using Y^X - Paul Dale - 02-28-2014, 02:11 AM
RE: WP34 resets when using Y^X - Randy - 02-28-2014, 03:22 AM
RE: WP34 resets when using Y^X - walter b - 02-28-2014, 09:44 PM
RE: WP34 resets when using Y^X - Randy - 03-01-2014, 12:13 AM
RE: WP34 resets when using Y^X - Marcus von Cube - 03-02-2014 02:50 PM
RE: WP34 resets when using Y^X - Paul Dale - 03-01-2014, 12:54 AM



User(s) browsing this thread: 1 Guest(s)