Post Reply 
Long last wanted: XEQ_Auto-Complete finally done
07-24-2017, 12:53 AM
Post: #43
RE: Long last wanted: XEQ_Auto-Complete finally done
(07-23-2017 09:10 PM)Sylvain Cote Wrote:  Hello Angel,

Thanks!

I am using the following setup on a 41CL (updated to: 2017-06-28) and on a HP-41CX with a Clonix-D module.
Code:
loaded WARPB1   at 0x830 mapped to page 8 bank 0  YCRC=0xD3E28A93  Rev:2017-07-23
loaded WARPB2   at 0x831 mapped to page 8 bank 1  YCRC=0x7705223D  Rev:2017-07-23
using  LIBRARY4 at 0x120 mapped to page 4 bank 0  YCRC=0xBF465233  Rev:2017-05-16
using  YFNX-2C  at 0x00A mapped to page F bank 0  YCRC=0x99BDA28B  Rev:2017-06-19 (CL only)

With the Clonix-D/HP-41CX everything went ok and the previous two issues has been resolved.

With the 41CL I am at lost here, it seems this is the first time for me that I am trying to plug bank-switched module from RAM.
I have tried the following ...
a) "4LIB 4" PPLUG "-830 8" PPLUG
b) "4LIB 4" PPLUG "+830 8" PPLUG
c) "4LIB 4" PPLUG "*830 8" PPLUG
each time the CL freeze big time and it take 30 minutes to get around it.
The 41CL Extreme Functions manual is no help here for me, I have read it several time but I do not see the pattern I need to do this.

Sylvain

The "*830 8" PPLUG should work. Perhaps there is something with the order
of modules in the Ports? I have YFNX in 8, YFNF in 9 and YUPS in F when I plug
4LIB into 4 and then *850 into C (I first copied the previous version of WARP to
850-853). Everything works okay with this setup.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Long last wanted: XEQ_Auto-Complete finally done - Monte Dalrymple - 07-24-2017 12:53 AM



User(s) browsing this thread: 3 Guest(s)