Plotter Module - PRCL command hangs in EMU41

[J-F Garnier]

(06-02-2017 08:39 PM)jch Wrote:  NEWPLOT is running fine with PyIlper, but of course, something must be wrong.

Do you have a way to make emu41 work with pyILPER ??
For sure it will interest some people here :-)

Quote:May I have swapped both halves of the ROM? Could it be that I downloaded a bad module from TOS?

The ROM must be installed in two consecutive even-odd pages.
In Emu41, you can check that the 4k ROMs are correct with the embedded debugger:
Ctrl-Z to enter the debugger,
c command, you should get '8: 17 PL-1A OK' and '9: 18 PL-2A OK',
r to return to emulation.

J-F