Post Reply 
41CL chips going EOL - how many 41CL boards are desired in the future ?
06-15-2017, 10:12 PM
Post: #14
RE: 41CL chips going EOL - how many 41CL boards are desired in the future ?
(06-15-2017 09:55 PM)Sylvain Cote Wrote:  Last question, about the enclosing case, will you offer the 3D printed case parts and if not, are the following HP-41 3D printed module parts will be compatible ?
HP-41 Mod Top : https://www.shapeways.com/product/87BQPB...d=58936151
HP-41 Mod Bottom : https://www.shapeways.com/product/3V68BQ...d=58936242

Sylvain

That case should work, and it's the one I would offer to use with the board. However, there is still the problem of the connector. I have been assuming that a donor connector would be used, because I don't know how to get one made (it was clearly custom for HP.) I know, that means destroying a module, but the same thing was required for the Clonix, so I figure it's what I'll have to do also.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: 41CL chips going EOL - how many 41CL boards are desired in the future ? - Monte Dalrymple - 06-15-2017 10:12 PM



User(s) browsing this thread: 2 Guest(s)