Post Reply 
Any Time Module experts out there?
07-28-2017, 08:14 AM (This post was last modified: 07-28-2017 10:23 AM by Ángel Martin.)
Post: #2
RE: Any Time Module experts out there?
I'm not an expert but here's some observations poking about the buffer contents, after creating alarms using XYZALM

1. the buffer header (bottom of the buffer memory) has the id# (AA corresponding to buffer #10) in digits <13:12>,and the buffer size in digits <11:10>

2. new alarms are added to the bottom of buffer, i.e right below the header - thus pushing up (in memory) the existing ones.

3. each alarm entry uses a variable number of registers (from 1 to 3 I believe), depending on the supplied information (message, repeat interval, date and time). I'm not sure where's the information on how many registers the entry uses, can't identify the digit pattern so far

4. Looks like the first register contains both the date and time, the second has the repeats or the message if only one of those is provided, and the third the message to display when both repeats and message are provided. The formats are not evident, must use either Julian dates or number of days after a reference date... I vaguely remember reading about that.

5. the last register (top of buffer memory) is always "F000000000000"

Hope this helps to get you started...
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Any Time Module experts out there? - Ángel Martin - 07-28-2017 08:14 AM



User(s) browsing this thread: 1 Guest(s)