Post Reply 
[WP-34s] Add radix in show digits of x display
03-16-2014, 03:41 PM
Post: #4
RE: [WP-34s] Add radix in show digits of x display
(03-16-2014 09:55 AM)Marcus von Cube Wrote:  
(03-16-2014 08:31 AM)Paul Dale Wrote:  What is the exponent doing there? In double precision, the exponent can have four digits.

The first image is for single precision, the second and third show double precision. The four digit exponent is shown in picture 2. I see no problems here. I think the only change is in the first line of the display, not the second.

We have to check how it looks without the nice fonts of the Qt GUI but I don't have any objections.

Yes, the only changes are for the upper line. And it is strictly to insert the radix after the first character. The code assumes that the number is being put into "scientific" mode and hence the radix will always be at the same location.

Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: [WP-34s] Add radix in show digits of x display - Jonathan Cameron - 03-16-2014 03:41 PM

User(s) browsing this thread: 1 Guest(s)