Multi Calculator Kit

[teenix]

Hi all,

I have no experience with 3D design but have been playing around with a case for the MiltiCalc with OpenSCAD for a few hours.

The result so far looks like a bit like a Lego brick but is interesting to play with and who knows, it might evolve into a reasonable 3D print.

The idea is that a printed key overlay (vinyl or similar) is placed on the top face and the buttons are flush with the top surface and shouldn't need much pressure to operate. The key holes are about 8mm square, or could be round, and should allow fingers to dip just below the top surface to activate the key.

cheers

Tony