Public Beta Availiable (v3) - Win/Mac/Firmware

[akmon]

Hello, I would like to share this strange crash on v3 beta version.
I attach the software that causes the crash. It´s about Morh´s circle (the program is not mine).
I start the program, insert the data required, but then, after choosing option 2 "Gráfica", the physical unit turns on white screen, and there is no other way to restart the unit but inserting a clip on its back.
And here is the funny thing. I run this app on the virtual calc and it works flawlessly!!

For better comparison, I did a factory reset on both units, and downloaded the app, only that, for no other software could disturb it, and the results are the same I described before.

1.- ¿Can you check on your physical unit if it behaves like I wrote?
2.- What is causing this crash? It didn´t happen in version 2.