Post Reply 
newRPL - build 1255 released! [updated to 1299]
12-23-2017, 11:38 PM (This post was last modified: 12-23-2017 11:40 PM by Claudio L..)
Post: #31
RE: newRPL - build 1001 released!
(12-23-2017 05:06 PM)Gilles59 Wrote:  Hello,

With the simulator (w10), how to kill a program (infinite loop for exemple)? On the 50g I press the ON but on the simulator ? The ESC key dont work for this, the only way I found is to close the program.

Another question to Claudio : are you considering to expand the available memory on the simulator ? It would be fine ;D Perhaps this could be user define ?

Same as in the calc, to break out of a program you use On+A+C, on the PC you have to press ESC+A+C. Now ESC sometimes gets taken by Windows (very annoying) and stops working, so I also mapped the key Home to On, therefore Home+A+C should work.
Keep in mind the simulator doesn't respond well to single key touches while the exception handler is running (I have no clue why, everywhere else the keyboard works fine), so once you get the Cont/Exit/Warmstart/Reset options, just press and hold B (Exit) for a few seconds until it works, it should stop and show an error message "Aborting RPL engine".
The On key by itself is too dangerous, it is too easy to accidentally stop a calculation in the middle.

EDIT: Sorry, forgot your last question: If you type MEM on the simulator, you'll see more than 1.1 MB free. I defined relatively small because that way there's more GC's and it helps me debug, as it crashes a lot more!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: newRPL - build 1001 released! - pier4r - 12-16-2017, 08:03 AM
newRPL - on Hp 39gs - Martin Hepperle - 06-05-2019, 06:51 AM
RE: newRPL - build 1001 released! - pier4r - 12-23-2017, 10:16 AM
RE: newRPL - build 1001 released! - Claudio L. - 12-23-2017 11:38 PM
RE: newRPL - build 1001 released! - pier4r - 01-01-2018, 09:42 AM
t - Claudio L. - 01-01-2018, 03:06 PM
RE: newRPL - build 1001 released! - pier4r - 01-01-2018, 03:41 PM
RE: newRPL - build 1001 released! - pier4r - 01-02-2018, 04:54 PM
RE: newRPL - build 1001 released! - pier4r - 01-02-2018, 06:58 PM
newRPL - brickviking - 10-05-2018, 06:01 AM
How to participate? - erazor - 12-13-2019, 07:12 AM



User(s) browsing this thread: 2 Guest(s)