Arduino Board as HP-IL device?

[Klaus Overhage]

Hello Sylvain,

please look at the pictures in my thread "Arduino IL Drive Sim read good write bad"
https://www.hpmuseum.org/forum/thread-14041.html

I use PILBox 2.1. Jean-Francois send it to me in october 2019 with this information:

"Your PIL-IO board kit with PIL-Box MCU has been shipped yesterday.
Assemble it as a standard PIL-IO board.
Then, since it uses the PIL-Box firmware, a jumper (provided) must be installed on JP2 to set the com speed to 115kbps."

Regards
Klaus