3d-printing a thinner HP41CX back cover

Threaded Mode | Linear Mode

3d-printing a thinner HP41CX back cover

02-26-2018, 07:29 PM

Post: #4

hth

Senior Member

Posts: 415
Joined: Mar 2014

RE: 3d-printing a thinner HP41CX back cover

(02-26-2018 07:02 PM)Didier Lachieze Wrote:
(02-26-2018 05:57 PM)rprosperi Wrote: the thickness of the upper portion cannot be reduced because of the ports for the 4 x ROM/RAM modules.

Unless you make it a real half-nut with 2 module ports

I am so eternally grateful they did not implement that plan.

Håkan

« Next Oldest | Next Newest »

Messages In This Thread

3d-printing a thinner HP41CX back cover - atilla457 - 02-26-2018, 04:52 PM

RE: 3d-printing a thinner HP41CX back cover - rprosperi - 02-26-2018, 05:57 PM

RE: 3d-printing a thinner HP41CX back cover - Didier Lachieze - 02-26-2018, 07:02 PM

RE: 3d-printing a thinner HP41CX back cover - hth - 02-26-2018 07:29 PM

RE: 3d-printing a thinner HP41CX back cover - Nate Martin - 02-27-2018, 04:58 AM

RE: 3d-printing a thinner HP41CX back cover - Massimo Gnerucci - 02-27-2018, 07:48 AM

RE: 3d-printing a thinner HP41CX back cover - brickviking - 02-27-2018, 07:58 AM

RE: 3d-printing a thinner HP41CX back cover - grsbanks - 02-27-2018, 11:01 AM

RE: 3d-printing a thinner HP41CX back cover - Massimo Gnerucci - 02-27-2018, 11:42 AM

RE: 3d-printing a thinner HP41CX back cover - Paul Dale - 02-27-2018, 08:04 AM

RE: 3d-printing a thinner HP41CX back cover - toml_12953 - 02-27-2018, 01:19 PM

User(s) browsing this thread: 1 Guest(s)