3d-printing a thinner HP41CX back cover

Threaded Mode | Linear Mode

3d-printing a thinner HP41CX back cover

02-27-2018, 07:48 AM

Post: #6

Massimo Gnerucci Offline

Senior Member

Posts: 2,655
Joined: Dec 2013

RE: 3d-printing a thinner HP41CX back cover

(02-27-2018 04:58 AM)Nate Martin Wrote: I just checked my boneyard and have about a half-dozen full nuts in various states of repair but no half nuts.

Isn't a half-dozen full nuts = a dozen half nuts?

:)

Greetings,
Massimo

-+×÷ ↔ left is right and right is wrong

« Next Oldest | Next Newest »

Messages In This Thread

3d-printing a thinner HP41CX back cover - atilla457 - 02-26-2018, 04:52 PM

RE: 3d-printing a thinner HP41CX back cover - rprosperi - 02-26-2018, 05:57 PM

RE: 3d-printing a thinner HP41CX back cover - Didier Lachieze - 02-26-2018, 07:02 PM

RE: 3d-printing a thinner HP41CX back cover - hth - 02-26-2018, 07:29 PM

RE: 3d-printing a thinner HP41CX back cover - Nate Martin - 02-27-2018, 04:58 AM

RE: 3d-printing a thinner HP41CX back cover - Massimo Gnerucci - 02-27-2018 07:48 AM

RE: 3d-printing a thinner HP41CX back cover - brickviking - 02-27-2018, 07:58 AM

RE: 3d-printing a thinner HP41CX back cover - grsbanks - 02-27-2018, 11:01 AM

RE: 3d-printing a thinner HP41CX back cover - Massimo Gnerucci - 02-27-2018, 11:42 AM

RE: 3d-printing a thinner HP41CX back cover - Paul Dale - 02-27-2018, 08:04 AM

RE: 3d-printing a thinner HP41CX back cover - toml_12953 - 02-27-2018, 01:19 PM

User(s) browsing this thread: 1 Guest(s)