Post Reply 
3d-printing a thinner HP41CX back cover
02-27-2018, 01:19 PM
Post: #11
RE: 3d-printing a thinner HP41CX back cover
(02-27-2018 04:58 AM)Nate Martin Wrote:  
(02-26-2018 07:02 PM)Didier Lachieze Wrote:  Unless you make it a real half-nut with 2 module ports Wink

No! No ports and a Lipo battery. We could get rid of the mid-piece bezel and bottom on a half nut. Direct power onto the main board and get rid of the battery flex circuit...

No ports? Then you have a DM-41!

Tom L
Cui bono?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: 3d-printing a thinner HP41CX back cover - toml_12953 - 02-27-2018 01:19 PM



User(s) browsing this thread: 1 Guest(s)