50g Hangs on Graphics

[Alvaro]

(04-30-2014 07:37 PM)Han Wrote:  Out of curiosity, what firmware are you using? You can find this with the VERSION command. Also, would you mind typing HEX (sets calculator into HEX mode) and then RCLF (recalls the current settings) and share what the list of hexadecimal values are? I am still unable to produce the behavior you describe. When I press LS+"Table" I only get a beep but no actual error message.

And your 50g does not hang after that beep?
Firmware version is 2.15
The RCLF command says this:
# 204010FF0h,# 0h
# 8000000042000000h
# 0h}