HP97 The journey begins
|
07-24-2021, 02:36 PM
Post: #398
|
|||
|
|||
RE: HP97 The journey begins
(07-24-2021 11:30 AM)Hans Brueggemann Wrote: try to go with either a 5mm (yes, 0.2") "hoof" or "spade" style solder tip and a very generous application of no-clean solder flux. worked like a charm on my 100-pin FPGA projects: the magic of using enough flux. it's really as simple as that. These are some magical videos! Important to note the author is using a quality soldering station and the proper tip as mentioned. The best surface finish is ENIG but specifying that bumps you out of the low cost prototyping category and into the regular commercial PCB category. Remember kids, "In a democracy, you get the government you deserve." |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)