Important - Reupdate your unit!

[Jose Gonzalez Divasson]

I managed to update it after a few attempts, but now it starts up through the hp sign, x2+y2=1 screen with the circle, and then it restarts again. Same cycle, and restart again. It does not work restarting with the clip on the back.

I have tried getting in the diagnostics page, and I manage to get there. I have formatted the C: drive, and then reset from option 9, but it continues to behave as before.

I see that the version available is v0.031.6030. PCB version 00

Any help? How can I reset it, or reload the firmware? It is not seen by the connectivity kit in this state.

Best regards