Hp-41C card reader - dead
|
05-17-2020, 12:39 PM
Post: #59
|
|||
|
|||
RE: Hp-41C card reader - dead
In my tool box I have found this cable.
Unfortunately I don't think it is good for the 'clutch' as it is quite stiff / rigid. Anyway I did some practiced stripping the inside insulation and I have a couple of questions: 1) the piece of insulation has to have a perfect center hole, correct ? 2) as the hole I have is too tight it doesn't fit onto the copper gear worm axle. Do I have to enlarge it a little bit before sliding it on ? I have a black satellite dish cable in the flat which sticks out from under the floor. This has a flexy feel and touch to it. I'm not using satellite at all so, maybe, I could cut a piece off this and hide the rest and give it a go ? Thank you Marco |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)