Hp-41C card reader - dead
|
04-24-2022, 05:17 PM
Post: #71
|
|||
|
|||
RE: Hp-41C card reader - dead
@teenix, I've tried with the RG58. This is the right size and once removed all the threads in the central hole fits snugly on the motor axle. I read the instructions in you pdf document. I do not have a lathe nor a drill tower nor anything else apart from a Dremel.
I enlarged the hole on the otherside of the internal insulation bit so tha the worm gear fits in it. I used a driil bit that is the same diameter of the worm gear. I placed the motor and assembly in its housing to see how much I have to cut off in order to get it to fit into its space. After cutting it I saw that it was already skewd. Did this three or four times with different pieces with sameresults, fortunately the cable is long :-) Tried attaching jpegs multiple times but it doesn't show them although I resized them to 400k They are loaded in the correct place of the forum but files are empty, I have 7 MB still available for uploads too Ideas? Marco |
|||
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 6 Guest(s)