New HP-41 Calculator Stand

[rprosperi]

I like your enthusiasm and taking up the challenge as intended!

For the PIL-Box, I'm not sure if this what you meant, but I think it would be best if the standard PIL-Box outer case/box could be accommodated. That obviously adds some height, maybe more than can be absorbed in the current design, but I'd say it's fine to let the PIL-Box just sit in a hollow under the stand, right on the desk underneath, if that simplifies the geometry, and the cables can be run through the holes on each side. I agree the angle for holding the 71B is important for comfortable use and the new design should not be forced to different angle/height to do this.

Project #2 looks interesting, I look forward to details when you're ready to share that.

Thanks tw!!