HP42S with non-volatile ram
|
02-06-2024, 03:54 PM
Post: #10
|
|||
|
|||
RE: HP42S with non-volatile ram
Greyuser and lyuka,
I have read with great interest the posts on adding en FRAM to the HP42S. I was wondering if the room between the PCB and the bottom of the calculator leaves sufficient room to add another PCB ? The case of the HP42S tapers to a lower height on the bottom (compared to the top). I understand the placing of the small protoPCB for the SN74LVC1G97. But it seems there is still some room to add a PCB with the width of the main PCB en and about 10mm height, if one glues this PCB to the EMC shielding. I have never opened my HP42S (3143S08979), so I have no idea if the free height between the EMC shield and the backside of the calculator is sufficient to add a PCB with SMD components. Could any of you give mee feedback on this ? best regards, Gert |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
HP42S with non-volatile ram - GreyUser - 06-11-2020, 04:40 AM
RE: HP42S with non-volatile ram - mfleming - 06-11-2020, 02:26 PM
RE: HP42S with non-volatile ram - toml_12953 - 06-11-2020, 03:58 PM
RE: HP42S with non-volatile ram - lyuka - 09-26-2020, 12:12 PM
RE: HP42S with non-volatile ram - GreyUser - 09-28-2020, 02:41 AM
RE: HP42S with non-volatile ram - lyuka - 09-28-2020, 01:13 PM
RE: HP42S with non-volatile ram - GreyUser - 09-29-2020, 01:41 AM
RE: HP42S with non-volatile ram - lyuka - 09-29-2020, 09:48 AM
RE: HP42S with non-volatile ram - lyuka - 11-17-2020, 06:11 PM
RE: HP42S with non-volatile ram - G-SAN - 02-06-2024 03:54 PM
|
User(s) browsing this thread: 1 Guest(s)